Install Instructions

Decal Installation: 
1. Clean and prep surface with 70% isopropyl alcohol.
2. Peel transfer paper from backing paper. If necessary, use a squeegee card to press down and better attach the transfer paper to the backing paper.

3. (Reflective Stickers) for reflective stickers need to be installed with the soap & water method. Spray down both the sticky side and application side with the S&W. 

4. Be sure the entire sticker is attached to the transfer paper sheet. Apply to a smooth surface such as a window. Use a squeegee card to help smooth down the decal to the surface.

5. Peel off the transfer tape off the sticker slowly. 

6. Extra: Use a heat gun to go over the sticker slightly.

Cut In Banner Installation: 
1. Clean and prep surface with 70% isopropyl alcohol.
2. Measure both sides of the windshield and leave a mark for the height at which you choose.
3. Install the banner with a mixture of soap & water for easy repositioning. 

Use a squeegee to get all the water and air out.
4. (Recommended) let the banner dry 20 min or use a heat gun before removing transfer tape on the lettering-design.
Caution: Don’t place the heat gun too close to avoid burn marks on vinyl. 

Layered Banner Installation: 
1. Clean and prep surface with 70% isopropyl alcohol.
2. Measure both sides of the windshield and leave a mark for the height at which you choose.
3. Install the banner with a mixture of soap & water for easy repositioning. 
Use a squeegee to get all the water and air out.
4. (Recommended) let the banner dry 20 min or use a heat gun before installing the letters.
5. Align and install the lettering with the same water & soap method.
6. Go over with a heat gun (hair dryer) to make sure the vinyl sticks before removing the transfer tape!
Caution: Don’t place the heat gun too close to avoid burn marks on vinyl.
 

FOLLOW US

  • Instagram
  • Facebook
  • YouTube

© 2020 AADesigns™. All rights reserved.  

Support@AADesigns.co

Kent, Washington